How do I program oscillate mode on a Flex monitor using the controller?

If your Flex Monitor has a wireless or panel-mounted controller, you can program oscillation patterns without using the SmartPlex App. This is ideal for in-field setups where quick deployment and directional sweeping are needed.

Step-by-Step Instructions

1. Enter Oscillate Program Mode

   • Hold down the Oscillate button on the controller for 5–10 seconds.

   • The controller will start flashing orange, indicating you're in Oscillate Program Mode.

2. Set the First Oscillation Point

   • Move the monitor to the first desired position in your sweep.

   • Tap the Oscillate button once.

   • The controller will flash white, confirming the position is saved.

3. Set the Second Oscillation Point

   • Move the monitor to the second sweep point.

   • Tap the Oscillate button again.

   • A second white flash confirms the point is accepted.

   🔹 A minimum of two points is required for oscillation to function.

4. (Optional) Add More Sweep Points

   • Continue setting additional points using the same process.

   • Tap the Oscillate button once at each new position.

5. Exit Program Mode

   • Hold down the Oscillate button again for 5–10 seconds.

   • The controller will turn blue, signaling that you’ve exited programming mode.

Run Oscillate Mode

1. Start Oscillation

   • Tap the Oscillate button once.

   • The controller will glow solid orange, showing that the monitor is oscillating.

2. Observe the Sweep

   • The controller will flash white each time the monitor hits a programmed point.

3. Stop Oscillation

   • Press any button or joystick on the controller.

   • The controller will turn blue, confirming exit from oscillation mode.