How do I install a wireless remote kit in a TFT electric remote monitor?

Power off the monitor, remove the lid and communication board, install the antenna and radio board, then reconnect everything. Ensure the antenna o-ring is properly sealed and all wires are tucked safely.

How do I pair a wireless remote or display remote to a TFT monitor?

Enter learn mode on both the remote and the monitor using a button sequence. For display remotes, access RFID Learn through the menu. Complete the pairing and power cycle both devices.

How do I search for repair or service information for my TFT product?

Use the search bar at the top of the page to find repair guides, troubleshooting tips, and service instructions by product name or keyword.

Where can I find support for ordering engraved or colored parts?

You can browse our articles on engraving, colored grips, and customizations or contact our Inside Sales team for assistance.

How do I install an program a wireless remote kit on a TFT electronic remote control monitor?

Installing a wireless remote kit allows your TFT electric monitor to operate remotely using a wireless handheld. This guide walks you through safe installation of the radio board and antenna, and includes linking procedures for both standard and display-equipped wireless remotes.

Part 1: Wireless Kit Installation

Tools & Materials Needed:

3mm socket head driver
17mm and 18mm wrenches
Blue Loctite
Anti-static wrist strap (recommended)
Radio kit contents:
- Antenna (900 MHz, 2.4 GHz, or 920 MHz)
- Radio board and adapter
- Locking nut

Step-by-Step Instructions:

Power Down the Monitor
- Disconnect power at the Deutsch plug.
- Confirm the green LED is off.
Remove the Lid
- Unscrew the lid (screws are retained).
- Carefully disconnect the ribbon cable by lifting the two side latches.
Remove the Communication Board
- Unplug the communication connector.
- Wiggle the board out—it's a tension fit.
Install the Antenna
- Remove the existing plug (17mm outside, 18mm inside).
- Insert the antenna through the hex-shaped receptacle.
- Ensure the o-ring is seated properly to prevent leaks.
- Apply blue Loctite, install the locking nut, and snug it down.
Attach the Radio Board
- Align the radio board with the white outline on the back of the communication board.
- Press gently until fully seated.
- Connect the antenna wire (threaded or press-fit depending on type).
Reinstall Communication Board
- Insert and seat the board with the coax facing rearward.
- Reconnect the communication plug.
- Tuck wires safely out of the way.
Reconnect the Lid
- Reconnect the ribbon cable (dark green contact side faces the board).
- Lay the cable flat, reseat the lid, and secure the screws in a crisscross pattern.

Part 2: Link the Wireless Remote (Standard and Display)

Standard Wireless Remote:

Power On Both Devices
Enter Learn Mode (Remote)
- Hold Left + Right buttons for ~5 seconds → add Up.
- Release all when red lights blink.
Enter Learn Mode (Monitor)
- Do the same button sequence on the monitor.
- Wait for lights to stop flashing.
Exit Teach Mode
- Press the Down button once.
- Power cycle both units.

If the link fails, reset the radio board:

Hold Down while powering on to clear previous data.

Display Wireless Remote:

Power On Both Devices
Enter Learn Mode (Remote with Display)
- Hold the button under Menu until screen changes.
- Tap Menu to find RFID Learn, then select.
Enter Learn Mode (Monitor)
- Same Left + Right → add Up button combo.
Confirmation
- Screen will show: “RFID Programming Complete”.
Exit Teach Mode & Reboot
- Tap Down once.
- Power cycle both devices to confirm functionality.

If linking fails, follow the reset process as described above and repeat the procedure.