Skip to content
English
  • There are no suggestions because the search field is empty.

How do I install and program a wireless remote kit on a TFT electric remote monitor?

This guide walks you through the complete process of installing a wireless radio kit into a TFT electric remote monitor and linking it with either a standard wireless remote or a wireless remote with display. Includes hardware installation, power safety, and step-by-step pairing instructions.

Whether you’re upgrading from a tethered remote or adding wireless capability to a new build, installing and programming a TFT Wireless Radio Kit gives your monitor remote control functionality. This guide includes instructions for installing the radio hardware, routing the antenna, and pairing both types of wireless remotes.

What’s Included in the Radio Kit

  • Antenna (900 MHz, 2.4 GHz, or 920 MHz depending on model)

  • Locking nut

  • Blue Loctite

  • Radio board and adapter (anti-static bag)

Part 1: Hardware Installation

1. Power Down the Monitor

  • Disconnect the Deutsch plug at the base of the monitor.

  • Confirm the green LED is off before proceeding.

2. Remove the Lid

  • Use a 3mm hex driver to loosen the lid screws (they're retained).

  • Carefully detach the ribbon cable from the lid by lifting the side latches.

3. Remove the Communication Board

  • This small board is on the far left inside the monitor.

  • Unplug the communication connector, then gently wiggle the board out.

4. Install the Antenna

  • Remove the existing plug from the antenna port (17mm outer / 18mm inner).

  • Insert the antenna, ensure the o-ring is seated properly, and apply blue Loctite to the threads.

  • Hand-tighten and then snug the nut with a wrench.

5. Attach the Radio Board

  • Align and press the radio board adapter onto the back of the communication board.

  • Thread the antenna wire into place (screw or press-fit depending on model).

6. Reinstall Communication Board

  • Insert the board back into its slot, with coax routing toward the back.

  • Reconnect the communication cable and tuck all wires safely.

7. Reconnect Ribbon Cable and Lid

  • Insert the ribbon cable (dark green contact side facing board).

  • Lock the connector tabs, lay the ribbon flat, and reseat the lid.

  • Tighten screws in a cross-pattern to ensure an even seal.

Part 2: Linking the Wireless Remote (Standard and Display)

Standard Wireless Remote

  1. Power on the monitor and remote.

  2. Enter Learn Mode on the Remote:

    • Press & hold Left + Right buttons → then press Up while holding.

    • Wait for the red lights to blink, then release.

  3. Enter Learn Mode on the Monitor:

    • Press & hold Left + Right, then Up.

    • Red lights will blink again, then stop once linked.

  4. Exit Learn Mode:

    • Press the Down button once.

    • Cycle power on both devices.

Having issues? Hold Down while powering on both units to reset the radio configuration and retry the linking process.

Wireless Remote with Display

  1. Power on both devices.

  2. Enter Learn Mode on the Remote:

    • Hold the Menu button until the display changes (~5 seconds).

    • Tap through the menu until you see RFID Learn → select it.

  3. Enter Learn Mode on the Monitor:

    • Press & hold Left + Right, then add Up until red lights blink twice.

  4. Link Confirmation:

    • The remote will show “Programming Complete”.

  5. Exit Teach Mode:

    • Tap the Down button once, then power cycle both devices.

If linking fails, reset both units by holding Down while powering on, then retry the procedure.